Quote:
Originally Posted by dsraven
post 2 above, 3rd pic down. shows the studs on the firewall where the inner fender gets bolted up. inner fender has a big hole there where the grommet installs. you would need to install the "L" bracket on the firewall with 2 nuts/washers and then on the inner fender the rubber grommet with the steel tube insert, then a bolt goes through the steel insert in the grommet and tightens up against the insert so the bolt gets tight but the grommet stays movable. should be a matching one on the other side. I think there is a large washer on each side as well. check the assembly manual.
|
Thanks man.
After you mentioned it I went back outside and looked and saw the two studs .... on both sides ...... so will have to fabricate something to use there. Should be fine.