Re: 57 Chevy Wagon - Californa Dreamin'
Been welding and grinding on the door edges to prep them for the filler I'll use to set the gaps. The patch panels I made for the bottom third of the doors didn't always end up where I planned, so a do-over is required. The gaps were pretty good from the factory on this old wagon, but there are always a few places that could be better.
I didn't like the way the dividers between the doors looked after moving the latch hardware around for the suicide rear doors. When the doors are open, you could see the recess from the stamping process on the backside. So I made a poster board template and transferred it to some flat sheet metal. With it welded in and ground smooth, it adds a ton of strength to the divider, plus it makes it look a lot nicer as well. The good news is, I'm running out of metal fab on the body shell and should transition to body filler in a week or so. I'll still need to do some fabrication work under the hood when I get the body on the frame and the front clip reassembled, but I can use the break.
|