Quote:
Originally Posted by Zippi
I'm assuming the 1" DD shaft will slide inside the tube with the hole at the column?
|
I must be explaining this poorly. but no. the 1"DD shaft will not slide in or even touch the tube with the hole at the bottom of the column.
you will put a u joint at the steering column. one side of the u joint will slide OVER the tube with the hole at the column. then the 1"DD side of the telescoping shaft will slide into that u joint on the other side.
same thing at the rag joint, you will take it off and the u joint with the 30 spline will go on the steering box in its place, and the 3/4"DD side of the telescoping shaft will slide into that u joint on the other side.
that slip shaft is not supposed to be out that far, it should be in as far as the rust is showing, about another 4".