The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post - Hooker Blackheart 1967-72 C10 Truck LS/LT Swap System Info Thread

**Jason Banks** · 01-18-2020, 04:26 PM

Thought I would update with some pictures of my test fitting. This is a stock 5.3 as pulled from a 2003 suburban with the truck oil pan and stock AC brackets. I thought it was interesting that the pan and ac compressor fit. I'm not using the factory AC brackets but the main part was still on the motor so I thought I would throw the compressor on to look. You would have to cut out part of the frame for the lines to be able to hook up as I have seen others using the low factory bracket have done.

This last photo shows how I had to cut a tab off the Anchor 3064 rubber mounts. I only had to cut it on the drivers side.

01-18-2020, 04:26 PM	#91
Jason Banks Senior Member Join Date: Dec 1999 Location: TX Posts: 1,519	Re: Hooker Blackheart 1967-72 C10 Truck LS/LT Swap System Info Thread Thought I would update with some pictures of my test fitting. This is a stock 5.3 as pulled from a 2003 suburban with the truck oil pan and stock AC brackets. I thought it was interesting that the pan and ac compressor fit. I'm not using the factory AC brackets but the main part was still on the motor so I thought I would throw the compressor on to look. You would have to cut out part of the frame for the lines to be able to hook up as I have seen others using the low factory bracket have done. This last photo shows how I had to cut a tab off the Anchor 3064 rubber mounts. I only had to cut it on the drivers side.