|
Re: Anybody with cpp 4° lowering blocks?
Best way to determine what degree shim or block you need is to measure. When I did the lowering on the 66 I put it on ramps all round and with the weight on the suspension went under and measured the angle at both ends of the drive shaft to see where I was at. I then machined the 1" blocks I was using to the angle I needed. Put 3 degrees on the top of the blocks.
Jimmy
__________________
60 to 66 Chevy and GMC window decals
http://67-72chevytrucks.com/vboard/s...d.php?t=661131
Good friends, good food and a hotrod what else do you need?
1966 BBW long fleet Daily driver
1965 BBW short fleet Sold and going to a good home
1965 Suburban
2003 3500 Duramax
2005 Ultra Classic
|