The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

washington blue · 02-10-2020, 11:33 AM

My junkyard wheels are going to hit the box when it is on. I need to figure out a way to space them out about 3/4 inch to roll it around in the shop. I really don't want to put on bling wheels until after I paint it because they will get filthy by the time it's done. Possibly just washers on the studs since the studs are 11/8 long, depends on the thickness of the aluminum I guess. Update- - - I found some 1 inch wheel spacers on E-bay for $28 bucks so I ordered them which should just about center the shop wheels.

02-10-2020, 11:33 AM	#138
washington blue Registered User Join Date: Mar 2016 Location: Not far from Sioux Falls South Dakota Posts: 328	Re: norms 55 chevy pu build My junkyard wheels are going to hit the box when it is on. I need to figure out a way to space them out about 3/4 inch to roll it around in the shop. I really don't want to put on bling wheels until after I paint it because they will get filthy by the time it's done. Possibly just washers on the studs since the studs are 11/8 long, depends on the thickness of the aluminum I guess. Update- - - I found some 1 inch wheel spacers on E-bay for $28 bucks so I ordered them which should just about center the shop wheels. Last edited by washington blue; 02-10-2020 at 12:28 PM.