The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post - Looking for advice

**cwcarpenter98** · 07-19-2020, 08:59 AM

My dad and I used this small router table he had. Was definitely a 2 man job since we had to run the boards over the table, but it worked out pretty well. We used two router bits to make it work. First pass cut down to where the strips sit on, second pass cut the deeper groove

07-19-2020, 08:59 AM	#57
cwcarpenter98 Senior Member Join Date: Jan 2018 Location: Hickory Flat, GA Posts: 4,432	Re: Looking for advice - wood bed 63 C20 My dad and I used this small router table he had. Was definitely a 2 man job since we had to run the boards over the table, but it worked out pretty well. We used two router bits to make it work. First pass cut down to where the strips sit on, second pass cut the deeper groove Attached Images __________________ Christian Carpenter 1963 C10 - Frankentruck 283, Muncie 3 speed with overdrive Overdrive wiring here 1963-ish truck bed trailer - Half-Wit 1981 C10 - Penny 305, th350 --> Soon to be 350, Saginaw 4 speed 1995 Dodge Dakota Sport "I'll put it simple: if you're going hard enough left, you'll find yourself turning right." - Doc Hudson