|
Re: Starting 1966 Factory Short Bed Build, Bagged, 383 Stroker and Muncie M20 4-Speed
Quote:
Originally Posted by 88Stanger
Ok, so after test fitting the old removed plate the new one is good, i just had to "massage" it in place. It is not welded in place yet, just test fitting for now. Fits good, door gaps are decent (more work on them later) but one small issue on the back inside edge of the new cab panel, the new door is just rubbing a small bit. I tried moving the dame door hinges till i was blue in the face. To get door gaps good, it still hits, so i think i need to just do a bit of "massaging" to that one area, ie. cut and lower that section just a bit. Comments?
(see pic with black wore off)
|
If exterior visual door gaps look good to you, massage the inner portion as needed.
__________________
67SWB-B.B.RetroRod
64SWB-Recycle
89CCDually-Driver/Tow Truck
99CCSWB Driver
All Fleetsides
@rattlecankustoms in IG
Building a small, high rpm engine with the perfect bore, stroke and rod ratio is very impressive.
It's like a highly skilled Morrocan sword fighter with a Damascus Steel Scimitar.....
Cubic inches is like Indiana Jones with a cheap pistol.
|