|
Re: Upside down, back to front, long low 63 fleet
These pics are a bit random and historical so I gotta cast my mind back a bit.
Cut the original panhard bar, threaded both the cut ends, turned out some solid bar and ran a tap right through. Adjustable bar now, set length at ride height.
Started working on cutting down the bedsides but realised I need the cab back on to do the many mods needed to match the bodywork to the kicked up chassis.
Had to make up a 1 piece tailshaft, had an old shaft that was too long with the right rear yoke to suit the diff. Fitted it with a new front yoke with the same u-joint as the rear and a new trans yoke. then took out the rear springs to check crossmember clearance at full down. All good.
The rolling chassi is almost complete so time to get into the cab. Radio speaker hole is a mess with lots of cut bars and the green!
|