Re: Yet another GMC build
Trying to problem solve. The terminator x system requires an MAT sensor. I used the hole up top to install a Haltech sensor for 300zx. I had already tapped that hole for 1/4 npt and plugged it but the location was handy. Most that I could find were either 1/8 or 3/8. The Haltech fit perfect. Below that I had installed an aluminum “tube plug” behind the throttle plate. Since I’m going turbo the Holley system requires a GM 2.5 bar MAP sensor. It won’t fit at the rear of the intake but I was able to drill that block off plate and attach the new map sensor onto it.
On a side note I’m feeling super fortunate that I ordered all my big parts a couple years ago. I see that my Trick Turbo manifold and Huron Speed 7875 are no longer available and my Terminator X max is on a lengthy back order.
|