[Too Slow '90]

I started the installation last weekend and was pretty optimistic until I set it in place. I removed the crossmember and set it in place. You can see from the pictures that I cut a small relief in the bed support for the roll over vent. In this location the flush fill cap will not fit. If I move it forward the roll over vent and sender will hit the bed support and the EFI cap will be under it. The fill cap is supposed to be in the middle of one of the boards but it hits dead center of the stainless steel bed strips.

It is supposed to be correct so and I'm wondering if anyone else had these problems. I have not received a response from Boyds.