The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

**kev2809** · 01-14-2022, 08:30 PM

Well, dropped this 5.3 4l60e in and with the sliders all the way back the Trans mount is a few inches short.

Are there any options out there to close this gap or am I looking at removing this crossmember and either moving it or buying aftermarket? I'm not pulling the motor back out, it was way to hard to drop in with my rocky driveway and short harbor freight hoist lol.

any advice welcome...thanks.

01-14-2022, 08:30 PM	#1
kev2809 low n' slo Join Date: Mar 2009 Location: rosenberg, texas Posts: 5,141	Trans mount idea Well, dropped this 5.3 4l60e in and with the sliders all the way back the Trans mount is a few inches short. Are there any options out there to close this gap or am I looking at removing this crossmember and either moving it or buying aftermarket? I'm not pulling the motor back out, it was way to hard to drop in with my rocky driveway and short harbor freight hoist lol. any advice welcome...thanks. Attached Images __________________ 67 1/2 ton Suburban - Project DRGNWGN. Build thread -_--_--_ _________ _--_-_ -/____\|__\|__\__ ,.,,,.,.,,.,\|_O _______ O_]