The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post - Help with removing rust from bare metal (pics)

**desert-rat** · 07-14-2022, 05:54 PM

So this is the current state of my cab. Bare metal and left outside. I'll explain more about that in another post. Upsetting story. Small claims court may be filed.
Anyway, it is a rough finish so rubbing a cloth across the metal left lint behind (close up pic). Not too bad though. Maybe I can still rub a cloth and use an air compressor to blow off the lint. I don't know.
But afterwards I still have to degrees it.
The pictures were not tooken sideways. Whatever.
LMK any ideas. Thanks.

07-14-2022, 05:54 PM	#1
desert-rat Senior Member Join Date: Jan 2013 Location: 3,018 feet above the SoCal/Mojave Desert region. Posts: 357	Help with removing rust from bare metal (pics) So this is the current state of my cab. Bare metal and left outside. I'll explain more about that in another post. Upsetting story. Small claims court may be filed. Anyway, it is a rough finish so rubbing a cloth across the metal left lint behind (close up pic). Not too bad though. Maybe I can still rub a cloth and use an air compressor to blow off the lint. I don't know. But afterwards I still have to degrees it. The pictures were not tooken sideways. Whatever. LMK any ideas. Thanks. Attached Images Last edited by desert-rat; 07-15-2022 at 12:52 AM.