Re: 71 K20 Idaho Edition
Got a few items done today in between helping with yard cleanup and hanging lights for the holiday. Made two trips to the store to exchange the wrong fan belt size.
Painted the z-bar shifter linkage and AC brackets so I can get that mounted. Finally got the alternator installed this afternoon.
Will shoot for installing the AC bracket and compressor from the Old Air Products kit this evening.
_____________________________________________________________________
Mechanical Left
-Install new belts
-Install Alternator
-Install radiator and hoses
-Install new mini torque starter
-Install fuel pump and gas line to carb
-Install new AC unit
-Install wire harness
-Make new battery cables and a few 2-gauge ground wires with same materials
-Install old exhaust so I can drive it to get new exhaust or buy builder kit and DIY it
-Drop of spare 205 transfer case to have rebuilt and twin sticks installed
(WIP)-Cleanup and replace terminal ends on electrical harness and repair where needed
Body Work Left
-Front fenders - wet sanded to 1500 need buffing or repaint
-Finish last 15% body work on hood: prime and paint
-Finish passenger door 25% of body work: prime and paint
-Finish driver's door 40% of body work: prime and paint
-Finish last 25% body work on bed: prime, paint and Raptor bedliner
-Body work cowl: prime and paint
-Paint both front fender wells
-Paint all four new shocks from lift kit to match body
-Body work used tailgate: prime and paint
-Install new grill and lights
Interior items
-Finish painting AC and light switch plate made from glove box, also paint radio delete plate for heater control area
-Install new seat cover
-Install new flooring and sill plates
-Install 3-point seat belts
-Install new gauge bezel, dash pad and other new goodies
|