[Duncan K]

Its been ridiculously cold here the last week which makes staying warm in the shop very inviting. Got some time to do a little machining project. Made some brake line clamps out of aluminum. Had to replace a leaky T fitting on the back axle for the rear brake lines. Secured the lines down the frame rail with the new brackets and got everything bled.



My front passenger fender had a big long flat spot all the way down the top of the front half. My hammer and dolly skills aren't that great yet so I decided it would be easier to just replace the damaged section. I found a fender with a good front half, chopped them up and made to into one.