I am down to just a few items before I can fire it up:
- Finish running fuel lines. I have all new hard lines from the fuel tank sending unit to the fuel pump and I will make a new line from the pump to the carb.
- Cooling system is done and ready to go
- I have my original wiring harness that I am cleaning up now. I ordered a few accessories to run the wiring properly. That all should be here this week which will allow me to finish up wiring.
- I need to install my trans cooler lines and top off the trans with atf.
- The factory throttle linkage that I have is not going to work with my holley carb. I need to order a new universal throttle linkage and return spring and that should be done.
I think that catches me up to current. Hopefully another week or two and it will be a runner. I also have new tires and my factory 15x6.5 steelies are at the blaster now. Once they are done I will throw some paint on them and mount my new tires. Then it should be a roller. My goal is by the end of February to have it sitting on all 4s and be able to hit the key and start it up. Still a long ways to go but hey these are milestones haha.