The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

**29od1** · 03-05-2012, 04:50 PM

And here are some pics of how I finished the driver's side front bracket. Basically the same concept in the front as I used on the passenger side.

Then I used some 1"x1/4" strap for the front to back sides and used some 3/8" thick strap on the back to spread the load out a bit for the rear attachment. The only thing I used from the stock bracket were the two U-shaped seat attachments.

03-05-2012, 04:50 PM	#15
29od1 Senior Member Join Date: Oct 2006 Location: Wichita, Kansas Posts: 1,050	Re: Adapting 2008+ GM SUV Seats to Blazer And here are some pics of how I finished the driver's side front bracket. Basically the same concept in the front as I used on the passenger side. Then I used some 1"x1/4" strap for the front to back sides and used some 3/8" thick strap on the back to spread the load out a bit for the rear attachment. The only thing I used from the stock bracket were the two U-shaped seat attachments. Attached Images Last edited by 29od1; 03-05-2012 at 05:08 PM.