01-07-2019, 12:03 AM
|
#75
|
|
Registered User
Join Date: Nov 2016
Location: Beaumont, Alberta
Posts: 468
|
Re: What's going wrong inside my 350?
Quote:
Originally Posted by dsraven
a gasket set is fairly cheap, get a felpro or another good quality set. pull the engine and strip it down, check everything, get it all to spec and reassemble. torquing everything as you go. then you will have the satisfaction of knowing what you have plus YOU did it. that feels good all by itself. you can do it and you will learn something as well. lots of help on this forum if you just ask.
when you take stuff apart just remember to keep parts that wear in together, like lifters on cam lobes and pushrods on rockers etc, together. and then assemble them in the same position. if all looks good you can likely just reuse the rings and bearings so it will be take apart, check, reassemble with new gaskets.
|
Noted. Thank you again DsRaven.
|
|
|