View Single Post
Old 09-29-2018, 09:05 PM   #5
'68OrangeSunshine
Senior Member
 
'68OrangeSunshine's Avatar
 
Join Date: Feb 2002
Location: Tucson, AZ USA
Posts: 6,983
Re: Clutch fork pivot ball clip install

Quote:
Originally Posted by LockDoc View Post
I am going to move this to the "Engine & Drivetrain" forum and see what they say there. It has been long enough ago that I did mine that I can't remember for sure, but I think I installed the clutch fork on the ball before I bolted the bell housing to the engine.....

LockDoc
You could probably do it either way, but I think if you put the clutch fork on after the bell housing is bolted up, it's easier to put the open ''claws'' of the fork into the throw-out bearing if the other end is free.
__________________


Every 25 years I like to rebuild that 292, whether it needs it or not.
'68OrangeSunshine is offline   Reply With Quote