The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

Sigsour7 · 10-10-2018, 01:10 PM

Hello everybody,

I have a 1950 chevy truck with a a super bad repair job. The entire back portion where the seat mounts begin all the way back to where the gas tank sits, which then leads to the outside. The entire "U" that you see from the outside on bottom portion of cab is all welded and bugered up.

If i plan on putting a bench seat back in it, do you guys think its worth/ or easier to fab my own floor pan out of sheet metal, or just finding a truck and pulling it out of that?

10-10-2018, 01:10 PM	#1
Sigsour7 Registered User Join Date: Sep 2018 Location: El Cajon Posts: 11	1950 Chevy Truck Floor Pan ? Hello everybody, I have a 1950 chevy truck with a a super bad repair job. The entire back portion where the seat mounts begin all the way back to where the gas tank sits, which then leads to the outside. The entire "U" that you see from the outside on bottom portion of cab is all welded and bugered up. If i plan on putting a bench seat back in it, do you guys think its worth/ or easier to fab my own floor pan out of sheet metal, or just finding a truck and pulling it out of that? Last edited by Sigsour7; 10-11-2018 at 02:04 AM.