Re: Stupid Question about placing engine mounts
Yes you want to keep all your driveline centerlines running parralel..whether offset side2side or vertically up&down...if your gonna offset to pass side make sure you have everything on the engine before you do...since your using the flat out xmember I assume you'll use the vett r&p as well..offsetting the engine isn't gonna help much with this setup,, but thats up to you...your gonna have a rollercoaster steering rod to get point a2b anyway..I'd try to stay at least a half inch off the firewall..if you do the recess firewall it'll give you more room up front...
I would set the trans xmember first..making sure it's a little higher than your frame or xmembers...then raise the engine to get your 3deg..
Either Tb and camaro manifolds are best...
|