Re: 67 C10 floor shifter conversion.
Note : I just consolidated my 3 speed info into one post, Mods - you can move its to the FAQ if you think it is useful.
OK - Hurst floor shift adjustment - Put tranny in neutral if possible, Loosen up nuts on shift linkage andfind a 1/4 inch drill bit. There is a hole in the side of the shifter, push the bit in hole moving shifter arounf if needed until bit aligns all of the parts. Insure shift levers on tranny are in neutral and tighten linkage nuts carefully, so that the arms stay in there neutal position. Go bang some gears -
Last edited by Green Machine; 11-04-2006 at 11:58 PM.
|