Re: Anyone tried the LMC "rod end linkage kit"?
in the middle of my 383 stroker swap on my 64 K10, I noticed all my clutch linkage parts were worn completely unsafely out...
so I decided to try the LMC rod end clutch linkage kit upgrade
part# 32-6161 (as previously mentioned! thanks! as it helps searching quite a bit!)
I'm not a very good instructions without pictures kind of guy, and what came with the kit was not informative to my addled brain... so I just put the stuff that came in the kit together and came up with what you'll see in the pics.
[I had some other issues with my new old block, and it lacking a hole drilled in the block for proper ball mounting so I fabbed my own rather than tapping block]
here's some pics of it installed, as mentioned, on a 1964 Chev K10, sbc 350 (383 stroker), with sm420 4spd trans, manual linkage:
__________________
1964 K10 shortbox Stepside
383 sbc stroker under vortec heads
sm420 trans / t221 tcase / corp 10 front axle / corp 12 rear axle / 3.73 gears
rolling on 33x12x15 tires on 6 lug rims.
|