graphed in the one piece dash yesterday
Also squeezed in the vintage air gen iv unit( its a big unit and tight fit due to the engine set back ,but its as snug as a glove).. after i cut out the original dash I mocked up the condenser, pre- ran all the lines, bulk head fittings made sure there was enough room for all the vent runs, and defroster vents, welded in threaded studs so the fire wall remains clean. If didnt do this when the dash was cut out and would have put the smooth dash in first, it would have been a nightmare to get it all put in.( Thanks rick mellon for that idea )
If you look way down there you can see how i ran the A/C lines and the heater lines just hidden under the A/C lines ( for a clean look with easy maintenance if need be,, the dryier is tucked up under the fender
Found some pre-molded heater lines so I can run them where It needed to be.
put in a more compact size hood latch and relocated
