The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post - 1965 C-10 LS build

rmvlt1100 · 01-11-2012, 12:49 AM

I got the engine and trans installed today. It was not easy. I had issues with the motor mounts. I have the CCP frame mounts, they worked great with the sbc, but it took some work to get them to get them to work with the LS engine. I read a few post about issues with these mounts and getting headers to clear. Has anyone ever had issues with motor mounts and these frame mounts? I used poly mounts from CCP. I'm not sure if this is going to be and issue but I had to remove the steel backing plate that is used with the poly mounts. After loosing up the frame mounts everything went together. After the wiring and saving up some money exhaust will be next.

The next picture is the next project. The harness is done just need to run the wires and clean up the harness. First I need to figure out where to put the computer.

01-11-2012, 12:49 AM	#11
rmvlt1100 Registered User Join Date: Jan 2012 Location: Crest Hill, IL Posts: 337	Re: 1965 C-10 LS build I got the engine and trans installed today. It was not easy. I had issues with the motor mounts. I have the CCP frame mounts, they worked great with the sbc, but it took some work to get them to get them to work with the LS engine. I read a few post about issues with these mounts and getting headers to clear. Has anyone ever had issues with motor mounts and these frame mounts? I used poly mounts from CCP. I'm not sure if this is going to be and issue but I had to remove the steel backing plate that is used with the poly mounts. After loosing up the frame mounts everything went together. After the wiring and saving up some money exhaust will be next. The next picture is the next project. The harness is done just need to run the wires and clean up the harness. First I need to figure out where to put the computer.