Re: 67 Plain Jane C10 396 build
I broke out the torch this morning and dimpled the frame for the steering box. I used my special tools; an old lower control arm shaft and an old ball from a lower ball joint.
I also notched the core support mount.
Next on the list of frame mods is to notch the frame for the big block. I took these patterns off a 68 C10 short coil spring frame.
The X's are the bolt holes for the engine mounts, etc...
__________________
Glenn
1960 Burro Corvair/VW Buggy - Factory made in Santa Ana, Ca
1929 Ford Model A Roadster - traditional pre-war banger hot rod
Last edited by ghalperin; 05-04-2017 at 06:18 PM.
|