The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

**67sss** · 09-04-2011, 05:58 PM

adjusting right side with no problem, when adjusting the left side no change when I turn the screw all the way in(I don't turn it to tight to screw up the seat) or all the way out. I've tried the "old fashion" way to try to loosen anything that might be caught by opening up the 4 brls-full throttle- and giving full choke(manual) to see if it'll suck it threw. No luck so far.

Also, the engine will not stay running at ANY steady throttle position. As long as I'm accelerating its fine, but the minute I try to stay at a steady throttle it'll fall flat on it's face. Mash the throttle and it'll kick down and go like a raped ape, even on freeway speed of 60.

Any ideas? Thanks.

09-04-2011, 05:58 PM	#1
67sss Registered User Join Date: Nov 2002 Location: Mt. Vernon, WA.. Posts: 2,322	air mixture screws on 1406 adjusting right side with no problem, when adjusting the left side no change when I turn the screw all the way in(I don't turn it to tight to screw up the seat) or all the way out. I've tried the "old fashion" way to try to loosen anything that might be caught by opening up the 4 brls-full throttle- and giving full choke(manual) to see if it'll suck it threw. No luck so far. Also, the engine will not stay running at ANY steady throttle position. As long as I'm accelerating its fine, but the minute I try to stay at a steady throttle it'll fall flat on it's face. Mash the throttle and it'll kick down and go like a raped ape, even on freeway speed of 60. Any ideas? Thanks.