View Single Post
Old 05-26-2019, 11:14 AM   #39
dracko
Registered User
 
dracko's Avatar
 
Join Date: Jan 2010
Location: Regina, SK
Posts: 773
Re: 68 C10 Yellow wire from firewall to starter/coil.

This thread is incredible. Tons of good info. Hoping for a little advice on wiring my new V8 and electronic ignition distributor. Itís EI but still has an external coil (Iím running a Pertronix with 1.5 ohm resistance). The dist. has 2 wires, red and black, Instructions just say to wire the red/black to the + and - terminals on the coil.

I understand i can get rid of the white braided resistor wire now that Iím not using points anymore, and the purple wire will still go to the starter solenoid,
But Iím not sure how to wire the starter to the coil?

Any info is appreciated.
dracko is offline   Reply With Quote