|
Re: Fatman, TCI, or Scotts IFS/Chassis on 49 AD
pinion angle with frame sitting on blocks, leveled.
engine angle-should be same but opposite as pinion
part numbers for the control arms, bushings etc
ball joint donor
brake rotor donor
brake caliper donor
brake pad donor
wheel bearing numbers inner/outer/seal
steering rack donor
inner and outer tie rod donor
rear brake size and donor
brake hose donor or custom size, specs for fittings etc
rear axle donor for axles left/right or part numbers for manufacturer match
diff gear ratio and brand if not a donor vehicle match
all info on diff, bearings, seals etc
4 link dimensions for bars, bushing sizes etc including panhard bar (assuming you will have a 4 link. if not then spring specs
|