View Single Post
Old 06-18-2017, 04:06 AM   #175
Registered User
520-k5's Avatar
Join Date: Jun 2013
Location: tucson,az
Posts: 182
Re: project orange crush 76 crewcab build

I welded the floor pan up the other day and I started on the inner rocker where it meets the floor hump and also patched the area where the inner rocker was too short. I found more rust on the inner rocker so I cut that out and notched over a little more. I got the outer rocker on tacked up but I left all my Cleco clamps and vice grips at work so I'll have to wait till this week to finish the outer rocker. I also test fit the door and everything is good to go I'll get the rocker finished as well as the outer cowl panel then I can move on to the passenger side
Attached Images
520-k5 is offline   Reply With Quote