Well, got the Off Road Design extended shock mounts for the front cut up & mounted in place. Ended up raising the mounting point for the new Bilstein 5125 shocks by 2 1/2" which should get the shocks close to the center of their travel at ride height and allow the axle to contact the bumpstop on the frame before bottoming out the shock.
Also installed the rear shock braces from ORD, well, just mocked them up and drilled the holes since the shocks need to get installed first, and I'm going to have to drop the rear axle again to correct the wheelbase & pinion angle, but need to have the engine back in the truck etc. first before I can do that.
