The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post - LS Mounts for Flatout Crossmember on a 55-59

**Dan in Pasadena** · 09-10-2018, 09:49 PM

Took me awhile to find them but I thought I had photos. We custom fabricated engine mounts that are welded onto a boxing plate immediately next to the Flat Out cross member.

As I was searching I found photos of the mounts but struggled to remember exactly where we mounted them? Finally found them. You can see the driver side one is shaped differently to go under the steering column.

Hope this helps some.

09-10-2018, 09:49 PM	#2
Dan in Pasadena Senior Member Join Date: Nov 2008 Location: Glendora, CA Posts: 6,333	Re: LS Mounts for Flatout Crossmember on a 55-59 Took me awhile to find them but I thought I had photos. We custom fabricated engine mounts that are welded onto a boxing plate immediately next to the Flat Out cross member. As I was searching I found photos of the mounts but struggled to remember exactly where we mounted them? Finally found them. You can see the driver side one is shaped differently to go under the steering column. Hope this helps some. Attached Images __________________ '55 Big Window Shortbed, Drive-It-&-Work-On-It slid down the "slippery slope" to a Frame-Off Rodstoration! LQ4/4l85e/C4 IFS/Mustang 8.8 rearend w/3.73's Dan's '55 Big Window "Build" - Well, Kinda!