[vectorit]

Hey Rob,
I used about 6 sheets, only because I messed up a couple times.
I tried to duplicate the number of panels that were used originally, and looking back, I think one could do the FRP route with larger panels instead smaller.

The front panel for me was the hardest, since it has a curve to it that is hard to duplicate on a flat sheet. I know I ruined one panel at least on that section, and one of the middle sections I cut too small.

So, if your store to buy these panels is far away. I would buy a couple extra just in case, and you can always return them if you don't use them.

Chris