View Single Post
Old 04-14-2017, 03:14 AM   #5
MP&C
Registered User
 
MP&C's Avatar
 
Join Date: Jan 2013
Location: Leonardtown, MD
Posts: 1,630
Re: help with car quarter panel trunk gap.

Did you do any planishing of the weld seam across the top? It appears the shrinking effect has pulled the rear of the quarter toward the center of the car.. I would focus some planishing effort on the weld seam, specifically toward the trunk opening, before attempting any slicing. If it doesn't help the issue, then go ahead with the slicing.
__________________
Robert
MP&C is offline   Reply With Quote