|
Re: Jackstands + no wheels = heavy vibration?
Quote:
Originally Posted by bob8619
Heres what I mean by questionable. Its hard to see in the pics but If you notice, the two caps that are going into the yoke are not even, this makes it seem like it would be off center but if you look at where the u joint lines up with that notch in the center of the yoke, it makes it appear as though its centered.
|
That'll do it, not centered as well as unseated bearings in cap. Could it be the needle bearings got dislodged in the cap, causing incomplete bearing with the one or ones that fell out laying in the cap preventing it from seating? Did you get the clips in both sides?
__________________
"BUILDING A BETTER WAY TO SERVE THE USA"......67/72......"The New Breed"
GMC '67 C1500 Wideside Super Custom SWB: 327/M22/3.42 posi.........."The '67" (project)
GMC '72 K2500 Wideside Sierra Custom Camper: 350/TH350/4.10 Power-Lok..."The '72" (rolling)
Tim
"Don't call me a redneck. I'm a rough cut country gentleman"
R.I.P. ~ East Side Low Life ~ El Jay ~ 72BLUZ ~ Fasteddie69 ~ Ron586 ~ 67ChevyRedneck ~ Grumpy Old Man ~
|