Partway done!
Header Buddies welded to the 3" coupler
Hand tightened up to the headers. The drivers side header has a slight down turn, compared to the passenger side, which appears to be level. Unfortunately this means I need to have the drivers side leg on the X-pipe turned to the side a little to compensate and make it all level again. This means a little less clearance, but ultimately shouldn't be a major concern, as long as it sits a decent ways off the ground!
You might be able to pick that "bend" up here in this picture. The exhaust is sitting upside down (Driver's side to the right). It has a little bit more "kick up" than the other side.
