The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

rip2174 · 06-20-2014, 08:38 PM

And here is I feel like a dumb arssh. Went to remove and a few of my tacks broke. I for sure thought welder had enough to tack sheet metal to 1/8 angle. But, while tacking noticed to just pooling up and not burning in. I *****ed and yelled and said let me look at the dam polarity again. Well this was the fifth time looking at the polarity settings and noticed I had it backwards this whole time. DUH!!!! Flipped them and it was was sizzling.

06-20-2014, 08:38 PM	#89
rip2174 Registered User Join Date: Apr 2013 Location: wilmington nc Posts: 492	Re: 83/84 swb stepside long time build And here is I feel like a dumb arssh. Went to remove and a few of my tacks broke. I for sure thought welder had enough to tack sheet metal to 1/8 angle. But, while tacking noticed to just pooling up and not burning in. I *****ed and yelled and said let me look at the dam polarity again. Well this was the fifth time looking at the polarity settings and noticed I had it backwards this whole time. DUH!!!! Flipped them and it was was sizzling.