Thread: S10 Swap how to
View Single Post
Old 06-17-2014, 07:12 PM   #20
Clay54
Registered User
 
Join Date: Dec 2009
Location: San Angelo, Texas
Posts: 268
Re: S10 Swap how to

Quote:
Originally Posted by skymangs View Post
Now we get to the meat and potatoes of how this build works. Attached you will see my frame swap cab stands, complete with measurements and pics so they can be duplicated for your build. The following schematic is for 47-50 cabs. These were center mount cabs, you will need to weld a 6"x6" 1/4" plate on the bottom of the floor on each side to re-enforce the floor for the new cab stands.

If you have a 51-54 cab, you will need to remove 1/2" from the "above frame" portion of the rear cab stands and add a 1/2" delron spacer above the stock S10 body mount (this fits between the factory floor braces)

I bend the lower legs out at a 15deg. angle to decrease stress on the side of the frame

both these use the stock S10 body mount bushings above the cab stands.
Thanks Chris for the hole measurements to put the S10 body mount bushings. Been waiting for them. Looking forward to whatever else you have to add to this thread. Thanks, Clay
Clay54 is offline   Reply With Quote