Finished stripping the frame today of everything except for the: front, trailing arm, and original transmission cross member. I'm going to leave them till I finish shortening the frame then I will bust the final rivets. I took off the upper control arm mounts off of the front cross member today as well. That was a task especially since I couldn't remember what happened to my air hammer. I remember using it in 2012, so who knows where it is now?
The short term plan is to cut and weld up the frame and cut the frame Ridetech kit which is susposed to be here tuesday this week. Then sandblast the frame the beginning of next week and paint if it is warm enough. I've been putting off buying a heater for the garage, maybe it's time I pull the trigger.