This is the tank I'll be using for my 70 C10 from Tanks Inc. # MU-H it comes with with the location for the sender at the top and a 3/8 pick up tube at the front of the tank or the back, depending on how you look at. My only concern is how to vent the tank with out adding or drilling any additional hole in the tank I called Tank Inc, and they just said to use a vented cap, but there has to be another way to vent it properly. I got this tank on ebay for $204.00. I was looking for something I didn't have to modify too much, and since My truck is bagged, the tank sits up in the frame. I had a LMC tank in there before. It just looked to ugly, and sat too low.. If anyone has any suggestions I sure would appreciate it...
I hope this link works...
http://www.tanksinc.com/cartimages/prod_zm_310.jpg