Re: Another Crew Cab, {72 Denali style}
Well a tiny bit of actual work, been moving stuff around and started wrapping up the cab to floor attachment. The plan is to use a piece of 72” angle iron tomato the cab back to the burbs floor support plate. Used screws to attach the angle temporality to the cab. Then plug weld and stitch weld the cab to the angle, then remove it all and wrap the sheet metail around the bottom. Skipping a few steps to get to the point. Lastly I’ll thru bolt everything to the floor to draw it right, and weld it to the floor. Sounds complicated but this way the original cab sheeetal will be sandwiched and uncut, hopefully stronger and easier to seal up.
|