Re: 3 point or 4 point seat belts in 52?
I used two 3 point and one lap belt in mine. I found them on ebay for reasonable and ordered the two side belts and a matching lap belt for the middle seat. Beyond the anchoring issues most aftermarket belts are set up for bucket seats. The AD bench requires a approximately 24 inches of belt long enough to pass up from the floor and over the seat top. I bought some matching belt, cut them to length and had the hardware sewn on. I also used the exterior grab handles as the upper anchor point. The middle belt serves to hold the center console/armrest in place. Think total parts cost was under $40 plus $10 for sewing ends on.
Last edited by vintovka; 09-22-2018 at 06:56 PM.
|