Re: how to place timimg tape?
you could install a knock sensor and monitor that voltage while driving and adjusting the timing etc. like a fuel injected engine computer does....
before you start that slippery slope yank the distributor out and do a check on bushings, shaft wear, weights and their pivot points, weight springs etc etc. if it needs a rebuild you could always just get a new distributor that is already curved to your likings, then do the same for the carb, check throttle shaft wear, base plate trueness, etc etc. or, again, for the price, just grab a new one with the stuff you like already set up.
then dyno
then talk to your tire supplier, haha
|