[88k5jimmy]

Originally Posted by randy500

I have the dash center vent and outer vent templates, cut from an old junk AC dash, just hold up and scribe. The outers and center I cut with a jig saw, it was very easy, just use an extra long blade so you can maneuver the saw around and keep the blade in the cut.

I have a firewall template too its kind of large though.
If you don't know you install the inside box in the same holes as Non AC, then slide the outer over the studs, mark a couple holes. Part of the center firewall needs to be opened up, the opening does not have to match factory AC it just needs to not impede air flow.

I could send you my templates if you send me a deposit and cover shipping both ways.

I'll send you a PM.

Thanks