The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post - Small block 400 build up...anyone running that setup?

veinbar · 03-05-2008, 03:19 PM

I would agree that it's hard to do better, and cheaper than the GM Vortec Cylinder Heads. Drill the steam holes, and make necessary cooling system mods. 400 ci, Vortecs, Dished Pistons, Edelbrock RPM Intake, 750cfm Q-Jet, Longtube Headers, Dual 2 1/4" Exhaust, and a slightly more than mild cam will do the trick. Good, proven cams that will give you the results you need;

http://store.summitracing.com/partde...2&autoview=sku

http://store.summitracing.com/partde...1&autoview=sku

Hope this was helpful,

-Jon

03-05-2008, 03:19 PM	#9
veinbar Registered User Join Date: Mar 2007 Location: Austin, TX Posts: 292	Re: Small block 400 build up...anyone running that setup? I would agree that it's hard to do better, and cheaper than the GM Vortec Cylinder Heads. Drill the steam holes, and make necessary cooling system mods. 400 ci, Vortecs, Dished Pistons, Edelbrock RPM Intake, 750cfm Q-Jet, Longtube Headers, Dual 2 1/4" Exhaust, and a slightly more than mild cam will do the trick. Good, proven cams that will give you the results you need; http://store.summitracing.com/partde...2&autoview=sku http://store.summitracing.com/partde...1&autoview=sku Hope this was helpful, -Jon