[67c10rustbuket]

Hey Darien I mailed those pieces out to you today, I'm a little slow this week I got sick somehow.... Anyway after looking at your pics again I agree with Steve that cutting off extra and filling it back with a strip would be a great idea. No big problem to fill that gap in. I also wanted to mention that you should make sure the rear of the floor edge is flush against the back of the rear cab support so the cab corner will fit over it. I can show you a pic if you like. That is why I decided to align everything from the one rear cab support hole. I then had to slot the seat belt hole up and rearward just a little then relocate the front holes. I have seen other trucks use this same piece without modification though so I just figure every truck is a little different. Later - Dan