The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

paintman · 07-03-2017, 12:44 PM

Dennis, How did you go about fastening the window channel felt ? The ones I took out of my truck were held in with screws. When I ordered new ones from Jim Carter it said they should be glued in place. What kind of glue would be used?

I think I am going to take a chance and order a set of window sweeps from Steele Rubber. Unfortunately a set from Steele is $60, and I have not had good luck with them in the past. The sweeps they sell have a cross section phot that shows the barrrel sidth is 5/32 which is larger then the ones I currently have.

I AM SO FED UP WITH THIS CHIT!!!!!!!!!!!!!!

07-03-2017, 12:44 PM	#25
paintman Registered User Join Date: Dec 2010 Location: washington NJ Posts: 766	Re: Progress on 46 Dennis, How did you go about fastening the window channel felt ? The ones I took out of my truck were held in with screws. When I ordered new ones from Jim Carter it said they should be glued in place. What kind of glue would be used? I think I am going to take a chance and order a set of window sweeps from Steele Rubber. Unfortunately a set from Steele is $60, and I have not had good luck with them in the past. The sweeps they sell have a cross section phot that shows the barrrel sidth is 5/32 which is larger then the ones I currently have. I AM SO FED UP WITH THIS CHIT!!!!!!!!!!!!!!