View Single Post
Old 07-31-2009, 09:31 PM   #1
60ratrod
yes, i do
 
60ratrod's Avatar
 
Join Date: Jun 2007
Location: Spokane, wa
Posts: 2,734
stumbling/misfiring at 2500-3000 rpms

ok so lately, as in the past few days, my truck(94 gmc stepside 4.3l auto) has been stumbling/misfiring at around 2500-3000 rpms(i can't tell exactly since i don't have a tach) while going down the highway. it only happens when i'm cruising, trying to maintain a steady speed. otherwise during any kind of acceleration, like gentle part throttle/hard wot acceleration she doesn't stumble, just when i'm cruising trying to maintain speed from 45mph-55mph. any ideas?? i checked the cap and rotor, i don't have any visible fuel leaks, i have spark on all 6 cylinders, only pulled one plug cause the motor was still too warm to attempt to pull off any of the other wires and it looked alright. the only mods that i have done are an intake, tbi spacer, msd coil, accel tune up kit(plugs wires cap rotor). could it be a ign module in the dizzy?? oh and the motor has about 145xxx so far as i can tell. oil was changed at 143,143(exactly), along with tranny fluid, filter, trans pan gasket, trans tail housing seal and bushing
__________________
ERROR 404....... SNAPPY COMEBACK NOT FOUND
_______________________________________________________________________________________________

-60 Chevy C10, dead 350/good th350 combo, sitting on a 76 c10 blazer frame, built from 11 different vehicles "the abomination"
-07 gmt900 silverado 1500 lt xcab z71, granite blue
-81 suzuki gs650g "shelah"- current project
-81 kz1000m1 csr "sarge" -next project (just beautification)
-07 kawasaki vulcan classic vn900

Last edited by 60ratrod; 07-31-2009 at 09:33 PM.
60ratrod is offline   Reply With Quote