The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post - Daddyjeep Hauler

Front Range · 03-27-2016, 10:41 PM

Just went through that on a passenger rocker, maybe these pictures will help a little. If I lay a straight edge across the original floor / inner rocker it sits roughly 3/8 to 1/2 inch above the new outer rocker seal lip / edge.

I didn't have to replace my inner rocker or floor. I lined my rocker up by hanging the door to check the lower gap and also using door measurements off the drivers side from top of door frame to rocker sill. That gave me a pretty good idea of where the new rocker needed to be. Hanging the door was the most beneficial.

03-27-2016, 10:41 PM	#63
Front Range Registered User Join Date: Jun 2014 Location: Longmont, Colorado Posts: 252	Re: Daddyjeep Hauler - 85 K30 crew cab short bed Just went through that on a passenger rocker, maybe these pictures will help a little. If I lay a straight edge across the original floor / inner rocker it sits roughly 3/8 to 1/2 inch above the new outer rocker seal lip / edge. I didn't have to replace my inner rocker or floor. I lined my rocker up by hanging the door to check the lower gap and also using door measurements off the drivers side from top of door frame to rocker sill. That gave me a pretty good idea of where the new rocker needed to be. Hanging the door was the most beneficial. Attached Images __________________ Folks that throw dirt on you aren't always trying to hurt you, and folks that pull you out of a jam aren't always trying to help you.