View Single Post
Old 02-20-2017, 01:26 PM   #34
VetteVet
Msgt USAF Ret

 
VetteVet's Avatar
 
Join Date: Jan 2005
Location: Kalamazoo, Michigan
Posts: 8,703
Re: Hard start question

Take your pick. I think any of them would work.

https://www.google.com/webhp?sourcei...all+block+chev

I pulled out all my starters about 10 and discovered that there are differences in the bell housing mounts. two of them had 2 bolt mounts and one was a 3 bolt mount which was smaller . I have a body with out a nose cone mounted that had come with an aluminum two bolt cone so I tried to put the small 3 bolt bell housing on that body and I had some trouble but it appears that it will fit.

There is a small dowel pin on the starter body that matches a hole in the nose cone and the cone has a ridge that goes into the starter body. Then the two long starter body bolts screw into the nose cone. I need to clean up some corrosion on the two pieces but it appears that they will go together.
It was late so I didn't have time to get into it so I will check today and report what I find.
__________________
VetteVet

metallic green 67 stepside
74 corvette convertible
1965 Harley sportster
1995 Harley wide glide

Growing old is hell, but it beats the alternative.
VetteVet is offline   Reply With Quote